EasyManua.ls Logo

Otto Bock B600 - Range

Otto Bock B600
96 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Ottobock | 33B600
The user is able to drive the product out of a hazardous
situation at any time. The product is fully functional again
once the unit has cooled down sufficiently (this may take
several minutes depending on the ambient temperature).
The power wheelchair is controlled by moving the joystick:
The further the joystick is deflected from the centre posi
tion, the faster the power wheelchair will drive in this dir
ection.
The maximum speed at full deflection of the joystick
depends on the selected speed level.
Releasing the joystick automatically activates the brake
function, bringing the power wheelchair to a halt.
The mechanical brakes are activated automatically when the
power wheelchair comes to a stop so that it cannot roll.
6.5.6 Range
INFORMATION
Information about the range of the power wheelchair
can be found in the chapter 'Technical Data'.
Please note that the specified range was determined
under defined conditions in accordance with ISO
7176-4. In practice the range can be reduced by up to
50%.
The following factors influence the range of a power wheel
chair:
Battery capacity
Age of the batteries
Ambient temperature
Driving conditions (e.g. terrain profile, condition of sur
face)
Charging method
Use of power options
Body weight of user
6.5.7 Drive-away lock
INFORMATION
The drive-away lock can only be activated as described
below if the function was previously enabled (see inside
front cover). The factory default setting can be changed by
the specialist dealer.
Please ask your specialist dealer about the setting selected
for you.
The power wheelchair control unit features an electronic
drive-away lock. This function is activated/deactivated via
the control panel.
The drive-away lock can only be activated or deactivated if
the "Drive-away lock" parameter is set to "Function
enabled". Unless otherwise specified in the order, the drive-
away lock is set to "Function disabled" at the factory.
If this setting needs to be changed, this is done by the
authorised person who fitted the wheelchair.
Usage

Table of Contents

Related product manuals