Otto Bock B600 - Replacing a Defective Bulb

Ottobock | 81B600
Closing the battery drawer (in models with drive wheel
suspension)
1) Push the battery drawer under the seat until the release
bolt engages.
2) Shake the battery drawer to ensure it is properly
engaged.
7.3.2 Replacing a defective bulb
NOTICE
Penetration of moisture
Risk of damage to the light
► During installation, ensure that the plates are seated
accurately in the housing.
► Ensure that the screws are seated tightly against the
plate.
INFORMATION
Lamp housings and lamps can both be ordered from the
specialist dealer.
The front lights have rubberised mounts to protect them
from damage.
Fig. 54 Front lights
1 Notch (place screwdriver here)
2 Front LED light
Replacing the front direction indicator lamp
> Remove the fuse (see previous section).
1) Place a small screwdriver into the notch in the direction
indicator housing and flip the cover down (see Fig.54,
item 1).
2) Remove the cover.
3) Turn the defective bulb slightly to unlock it and then
remove it.
4) Grasp the new bulb with a cloth, insert it into the socket
and lock it in place.
5) Position the cover, hook it on and press it down tightly.
Maintenance/Repair