4. Quick Start
This chapter states the matters need to attention before first power
on, and how to power on at first time, introduces spectrum
analyzer’s front/top panel and user interface, explains how to use
the instrument with a measurement example demonstration.
4.1 General Inspection
When you receive your new instrument, it is recommended
that you check the instrument following these steps:
1.Check for transportation damage.
If it is found that the packaging carton or the foamed plastic
protection cushion has suffered serious damage, do not throw
it away until the complete device and its accessories have
been electrically and mechanically checked.
2.Check the Accessories
The supplied accessories are described in the "Appendix A:
Enclosure" of this Manual. Please ensure that all the listed
accessories are present and undamaged, if any problems are
found please contact your distributor or our local office.
3.Check the Complete Instrument
If there is any physical damage, operational fault, or
performance issue please contact your distributor or our local
office. If there is any damage to the instrument please ensure
you keep the original packaging. Ideally you should always
keep the original packaging if the instrument must be returned
for repair.
4.2 Safety Precaution before Operation
4.2.1 Power Supply Requirements
The analyzer allows the use of either an internal lithium battery
pack, or AC-DC adapter shipped with the analyzer for its power
supply.
The lithium battery is 7.4V, 9100 mAh.
The table below lists the requirement of the AC-DC adapter.
To Next Page
Loading...
Need help?
General
