5.10.3 [Sweep Cont]
Press [Sweep Cont] to set the sweep mode to continuous sweep.
The analyzer performs one sweep after another as soon as it is
triggered.
5.11 【Trig】 hardkey
Key access:
Press Shift key, then Trig hardkey (5 in numeric keypad).
Sets the trigger mode and other associated parameters, submenu
includes [Auto Run], [Video], [External >].
5.11.1 [Free]
Set the trigger mode to free run mode. In this mode, new sweep
starts as soon as possible after the current sweep ends.
5.11.2 [Video]
In Video mode, a trigger signal will be generated when the system
detects a video signal in which the voltage exceeds the specified
video trigger level.
Use the numeric keys, knob or direction keys to set the trigger level
in Video mode. The screen will display corresponding line Triger
Level and the value.
5.11.3 [External >]
In this mode, an external signal (TTL signal) is input from the [Trig
In] connector at the top panel, of which the edge conditions should
meet with the user settings to generate trigger signals.
Press [External >] to access the submenu, select [Positive Edge]
or [Negative Edge] as the trigger condition.
5.12 【Source】 hardkey
Key access:
Press Shift key, then Source hardkey (6 in numeric keypad).
To Next Page
Loading...
