Quasi-peak detector is a weighted form of
peak detection. The measured value drops
as the repetition rate of the measured signal
decreases. It is used in EMI testing.
5.8.1 [Trace 1 2 3 4 5]
Select the trace, the spectrum analyzer provides 1, 2, 3, 4, 5 traces,
the selected trace number and the status menu item in which the
trace is located will be underlined. Where the color of the number
corresponds to the color of the trace.
5.8.2 [Pos Peak]
Searches the maximum from the sampling data segment and
displays it at the corresponding pixel.
5.8.3 [Neg Peak]
Searches the minimum from the sampling data segment and
displays it at the corresponding pixel.
5.8.4 [Sample]
Chooses any point data from the sampling data segment and
displays at the corresponding pixel. This mode is usually used for
video averaging and noise frequency Maker.
5.8.5 [Normal]
When noise is detected, the positive and negative peaks are
alternately displayed, otherwise only positive peaks are displayed.
5.8.6 [Voltage Avg]
Set the detector to the Voltage Average detector mode. This mode
calculates the average voltage of all the samples in the sample
bucket.
5.8.7 [More >]
Enter detection more menu.
5.8.7.1 [RMS Avg]
Set the detector to the RMS Average detector mode. This mode
calculates the RMS average power of all the samples in the
To Next Page
Loading...
