the spectrum analyzer built-in and user-defined measurement
function soft menu, turn on or off the time spectrum, adjacent
channel power measurement, channel power measurement,
occupied bandwidth, Pass-Fail measurement menu.
5.17.1 [Measure off]
You can directly close the currently running measurement function,
you can also choose to close the measurement menu.
5.17.2 [Time Spec On Off]
Turn on time spectrum measure mode.
5.17.3 [ACPR On Off]
Turn on or off the adjacent channel power measurement.
Press 【Meas Setup 】 to enter the parameters of the adjacent
channel power measurement submenu. The adjacent channel
power is used to measure the ratio of the adjacent channel power
of the transmitter. The absolute value of the main channel power
and the absolute value of the adjacent channel power are obtained
by the linear power integration method, so that the adjacent
channel power ratio is gained.
5.17.4 [Chanel Power On Off]
Turn on or off channel power measurements.
Press 【Meas Setup 】 to enter the channel power measurement
parameter settings submenu. The channel power is used to
measure the transmitter channel power, according to the user set
the channel bandwidth, through the linear power integration
method to obtain the absolute value of the main channel power.
5.17.5 [OBW On Off]
Turn on or off the occupied bandwidth measurement.
Press 【Meas Setup >】 to enter the parameter setting submenu
for occupying the bandwidth measurement. Occupied Bandwidth is
a measure of the bandwidth occupied by the transmitter signal can
To Next Page
Loading...
Need help?
General
