108
Instruments and controls
Increasing or decreasing the interval:
– Switch on intermittent wipe (position
---).
– When the windscreen wipers are
inactive (wipers fully down), turn
switch (5) to the zero position
(position 0) for a period of two to 20
seconds.
– After 10 seconds (for example),
switch intermittent wipe on again
(position ---).
The new interval is now 10 seconds (the time that the switch (5) was in 'position 0').
If the ignition is switched off, or if the intermittent wipe is not switched on for 5 minutes,
the interval reverts to the standard interval of 5 seconds.
In winter conditions, to prevent damage to windscreen wipers, always switch off the
windscreen wipers before putting the ignition key in the rest position.
Main beam
The main beam is activated when the headlights (dipped beam) are switched on and
the steering column switch is moved forward (6).
Headlight flash
The headlight flash is activated when the (spring loaded) steering column switch is
moved backward (7). The headlight flash goes off when the steering column switch is
released.
3.3.9 Right-hand steering column switch
Engine brake or retarder control using the steering column
switch
Depending on the version the brake control function on the steering column switch is:
– with MX Engine Brake or retarder (marked 'A' in the pictures).
– with exhaust brake (marked 'B' in the pictures).
The right-hand steering column switch can be fitted with the push knob for the Eco
Mode function. See section 'Eco Mode function' in chapter 'Driver assist systems'.
D001581
5
5
DW63246305.book Page 108 Friday, March 22, 2019 4:54 PM
To Next Page
Loading...
