223
Driving
– the brake pedal is not applied.
– the clutch pedal is not applied.
– the Engine Speed Control is not active.
If any of the above-mentioned statuses change, the engine electronics stops counting
and resets the timer. As soon as the conditions are met again, the engine electronics
resumes counting.
Restarting the engine
First turn the key fully back to the
position 0 (St). Then restart the engine.
7.9 ENGINE SPEED CONTROL
Engaging and disengaging conditions for Engine Speed
Control
Engaging Engine Speed Control
Engine Speed Control can be engaged when:
– the vehicle is stationary and
– the engine is running and
– the park brake is applied and
– the clutch pedal is not operated (not applicable for an automated gearbox) and
– the brake pedal is not operated and
– the MX Engine Brake is noot engaged and
NOTE: Some of these parameters can be changed to allow Engine Speed
Control to be used when driving below a maximum programmable speed
Disengaging Engine Speed Control
Engine Speed Control is disengaged when:
– switched off using the steering wheel switches or
– the park brake is released or
– the automated gearbox is switched from neutral (N) to a gear or
– the clutch is operated (not applicable an automated gearbox) or
D001669
A
0
S
D
(D)
(M)
(ST)
DW63246305.book Page 223 Friday, March 22, 2019 4:54 PM
To Next Page