18
Warnings and safety regulations
1.3 BEFORE YOU START DRIVING
Calibrating axle load monitoring system
If the vehicle is equipped with an axle load monitoring system, this system needs
calibrating before the vehicle is taken into service.
See section 'Axle load calibration' in chapter 'Air suspension' for the proper procedure.
Calibrating Tyre Pressure Indication (TPI)
If the vehicle is equipped with Tyre Pressure Indication (except vehicles with steered
trailing axle), this system needs calibrating before the vehicle is taken into service.
See section 'TPI (Tyre Pressure Indication)' in chapter 'Driver assist systems' for the
proper procedure.
1.4 WARNINGS AND SAFETY REGULATIONS
WARNING! Not observing the following safety regulations can
seriously jeopardise one's health and safety and can damage the
vehicle and lead to hazardous situations.
– Always observe the safety instructions in this manual and do not
ignore them.
– Also read the instructions and warnings on the labels and stickers
on the various components of the vehicle and comply with them.
They have been put there for your health and safety, so do not
ignore them.
WARNING! Driver Assist Systems such as ACC and AEBS are merely
intended to assist the driver in the performance of his or her duties.
Driver Assist Systems do not prevent accidents and they do not take
over the responsibility of the driver.
TPM Tyre Pressure Monitoring Sys-
tem
Using sensors in the tyres, TPM
measures pressure and temperature
of the tyres of the vehicle. The values
and possible warnings are displayed
on the master display.
VSC Vehicle Stability Control The Vehicle Stability Control signals
a pending instability and, if neces-
sary, intervenes.
VIC-3 Vehicle Intelligence Centre - ver-
sion 3
The VIC-3 gathers information and
actuates vehicle functions.
Abbrevia-
tion
Explanation Function
DW63246305.book Page 18 Friday, March 22, 2019 4:54 PM
To Next Page
Loading...
