170
Inspections and maintenance
Using the exterior light check function
1. Before getting into the cabin, press
the exterior light check switch (1) on
the ignition key or hand-held
transmitter for at least two seconds.
2. Now the exterior light check function of the vehicle starts.
The exterior lights are activated in the following sequence:
– The front fog lights or dipped beam and the brake lights are active.
– All direction indicators are active.
– The main beam and roof lights (sky lights or auxiliary lights) and the reverse
lights are active.
– The dipped beam and rear fog lights are active.
NOTE: All marker lighting is continuously active during the exterior
lights check.
NOTE: Defects are not stored and displayed on the master display as
the ignition is still switched off.
The total procedure repeats itself several times to provide enough time
to walk around the vehicle.
3. To stop the check, press the exterior light check switch for one second or press the
door lock or unlock button on the ignition key or hand-held transmitter.
5.1.8 Air filter indicator
The air filter indicator is located
immediately behind the air filter at the
rear of the cabin.
If the indicator is in the red area, the air
filter is seriously fouled and must be
replaced. Consult a DAF Service
dealer.
Clogged air filters lead to increased fuel
consumption and loss of power.
1
D001805
DW63246305.book Page 170 Friday, March 22, 2019 4:54 PM
To Next Page
Loading...
