118
Instruments and controls
The telephone can be reconnected as follows:
– Press the 'end call' key to open the connections screen.
– Select the telephone to be reconnected.
– Press the 'pick-up call' key. The telephone is now connected.
NOTE: Disconnecting and reconnecting telephones can also be done in the
'telephone' menu of the master display using the Menu Control Switch
(MCS).
3.5 RADIO
3.5.1 Basic radio
Controls
CAUTION: Operating the radio while the vehicle is in motion can result
in a distraction from the road and traffic conditions.
It is possible to lose control of the vehicle combination.
Only operate the radio if the traffic conditions allow it.
If the DAF Basic radio is installed in the vehicle, it is possible to use the steering wheel
switches to control the DAF Basic radio.
For operating the DAF Basic radio see the DAF Basic radio manual.
In this driver manual, only the specific DAF functionalities are described.
Input connections
The input connections are combined in the centre console.
The connection for audio streaming is placed near the ashtray; see section 'Centre
console'.
USB Connections
Using the USB connection near the ashtray, close to the DAF Basic radio, it is possible
to connect a USB storage device to the DAF Basic radio.
MP3 and WMA audio formats are recognised and played via the DAF Basic radio.
To select the USB input, use the source button on the DAF Basic radio until the name
of the USB device is displayed.
The USB connection also has a 500 mA power supply. It can be used to charge the
connected device, such as an MP3 player or a mobile phone.
NOTE: The DAF Basic radio does not support Apple® devices, such as an
iPod® or iPhone®.
When fitted, the USB connection on the other side has a 1.8 A power supply. It can only
be used to charge connected devices, such as an MP3 player or a mobile phone.
See section 'Centre console' in chapter 'Instruments and controls'.
DW63246305.book Page 118 Friday, March 22, 2019 4:54 PM
To Next Page
Loading...
