168
Inspections and maintenance
If the warning is red, add 10 litres of oil.
NOTE: The warning symbol remains active for 40 seconds. This warning
can only be activated when the conditions to perform an oil level check are
met.
So, to be able to perform an oil level check after topping up the oil level the
engine must not be started.
Topping up engine oil
CAUTION: An incorrect oil level can seriously damage the engine.
– Make sure that the vehicle is standing on a flat and level surface
when the oil level is checked.
NOTE: For topping up
engine oil use the same
engine oil brand, grade
and ACEA class as the oil
filled at the last oil change.
Only use engine oil that
meets DAF specifications.
See section 'Engine oil' in
the chapter 'Technical data'.
– Open the front panel. See section 'Opening the front panel'.
– Remove the filler cap (2).
– Top up with small amounts of engine oil (maximum 2 litres each time) through the
filler opening.
NOTE: Do not top up above the maximum level.
– Between each fill, switch off the ignition, wait a few minutes and check the oil level
via the master display:
– Switch off the ignition for at least one minute.
– Switch on the ignition. Do not start the engine.
– Check the engine oil level using the master display ('Vehicle info' - 'Oil level').
– Install the filler cap.
– Close the front panel.
5.1.6 Windscreen washer fluid level
The master display shows the 'Washer fluid level low' warning when the windscreen
washer fluid level is too low.
D001772
1
2
DW63246305.book Page 168 Friday, March 22, 2019 4:54 PM
To Next Page
Loading...
