39
Theft protection systems
Deactivating the alarm system
Pressing button (2) deactivates the alarm system, unlocks the driver's door and
switches the delayed interior lights on. The hazard warning lights flash three times to
indicate the alarm system is deactivated.
If the unlock button is pressed a second time within three seconds after unlocking the
driver's door, the co-driver's door will be unlocked.
NOTE: If no door is opened within 30 seconds after unlocking, the doors
automatically re-lock and the alarm is reactivated..
2.3.2 Self-diagnosis
The alarm system (ALS-S) has an extensive self-diagnostic function. Following
activation, all detection circuits (for the interior, load space, cabin tilting mechanism and
doors) are automatically tested.
If a fault is found in one or more of these detection circuits, the affected circuits are
switched off. This is made noticeable by a short signal from the siren immediately after
activation of the alarm system.
If this signal is heard, first of all check whether the windows and doors are closed
properly.
Switch off the alarm system, close everything carefully and switch on the alarm system
again. See section 'Using the ignition key or hand-held transmitter'.
If the short signal is heard once again, this means that the system is (partially)
defective. Visit a DAF Service dealer to check the system.
2.3.3 Use when staying in the cabin
If people remain in the cabin, the system may only be activated if the cabin interior
detection is switched off. This avoids unnecessary sounding of the alarm.
NOTE: If the interior detection is not activated, the alarm still works on the
doors, the cabin lock and cargo space. The start lock is also activated.
The cabin interior detection is deactivated as follows:
1. Deactivate the alarm system.
2. Press the 'Alarm cabin interior
detection off' switch. The system
LED lights up for approximately 2
seconds.
DW63246305.book Page 39 Friday, March 22, 2019 4:54 PM
To Next Page
Loading...
