166
Inspections and maintenance
WARNING! Coolant is a toxic fluid. Physical contact can lead to
serious health problems.
– If there is contact with the eyes: rinse with plenty of water for at
least 15 minutes and consult a doctor.
– Avoid prolonged or repeated contact with the skin. If there is
contact with the skin: rinse the skin profusely with plenty of water.
– If swallowed: do NOT induce vomiting. Rinse the mouth, drink two
glasses of water and consult a doctor.
CAUTION: Topping up coolant in a hot and running engine can
damage the engine.
– Top up when the engine is not running.
– Top up when the engine is cold.
– Top up slowly with coolant.
NOTE:
– Make sure that the
vehicle stands on a flat
and level surface when
topping up coolant.
– Always use coolants
which meet the DAF
specifications. See
section 'Coolant' in the
chapter 'Technical data'.
1. Open the front panel. See section 'Opening the front panel'.
2. Remove the filler cap (1) of the cooling system.
3. Check the coolant level. The coolant level must be at the base of the filler opening.
4. If necessary, top up the coolant with the specified coolant. See section 'Coolant' in
the chapter 'Technical data'.
5. Install the filler cap.
6. Close the front panel.
NOTE: If the coolant frequently needs topping up or there are any signs of
coolant leakage, consult a DAF Service dealer.
5.1.5 Engine oil level
The engine oil level can be checked on the master display.
NOTE: The oil level can only be measured and displayed when the engine
is not running.
D001772
1
2
DW63246305.book Page 166 Friday, March 22, 2019 4:54 PM
To Next Page
Loading...
