131
Instruments and controls
lots of wind and so on) the
engine coolant is kept on a
temperature above 0° C.
NOTE: The auxiliary heater switches off and must be restarted by pushing
key (11) when the ignition key is turned from OFF to ON or from ON to OFF.
On the timer function
Depending on the type of auxiliary heater fitted, using the timer, only the cabin is
preheated or in addition also the engine coolant is kept on a temperature above 0° C.
NOTE: Using the timer function the auxiliary heater can only be switched on
for a maximum of two hours. Keep this in mind while setting the timer.
NOTE: The Climate Control Panel uses the temperature and time settings
as set on the instrument panel.
Setting the timer
– To set the timer, the ignition key must be in the accessory position.
– Switch on the timer function by operating soft key (4) on the Climate Control Panel
(CCP).
– The CCP is now activated.
– Switch the timer on by turning the rotary switch (2) from OFF to ON.
– Confirm the selection by pushing soft key (14) to set the timer.
– Select the day of the week by turning the rotary switch (2).
– Confirm the selection by pushing soft key (14).
– Select the hours by turning the rotary switch (2) and confirm by pushing soft key
(14).
– Select the minutes by turning the rotary switch (2) and confirm by pushing soft key
(14).
D005154
A B C E F G I J
K
H
D D
DW63246305.book Page 131 Friday, March 22, 2019 4:54 PM
To Next Page
Loading...
