214
Driving
If you continue to drive the vehicle, the
Emission Aftertreatment System will be
permanently damaged! Stop the vehicle
as safely as possible and stop the
engine. At this point, you can no longer
initiate a forced stationary regeneration.
An authorised Service dealer must
service the vehicle before it can be
driven normally again.
Initiating a forced stationary regeneration
Enabeling conditions for a forced stationary regeneration
A forced stationary regeneration can only be activated if:
– the EAS indicates that regeneration is required on the master display and
– the engine is running at idle and
– the Engine Speed Control is not active and
– the vehicle speed = 0 and
– the PTO is not used (depending on the parameters of the engine management
system) and
– the throttle is not operated and
– the service brake is not operated and
– the park brake is operated and
– the clutch is not operated (not applicable for automated or automatic transmissions)
and
– the transmission is in neutral and
– the engine management system allows a stationary regeneration (for example,
coolant temperature above a certain value) and
– the regeneration inhibit position of the DPF regeneration switch is not selected on
the control switch.
If all of the above conditions are met, a forced stationary regeneration can be initiated.
Disabeling conditions for a forced stationary regeneration
If one of the enable conditions becomes inactive during the stationary regeneration, the
stationary regeneration stops immediately.
WARNING! Never initiate a forced stationary regeneration in a closed
building or enclosure, or in an area where people or combustible
vapours and materials are less than 2 metres away from the vehicle.
Always park the vehicle outside and away from all combustibles and
bystanders, and make sure that no one is in the immediate vicinity.
Failure to do so can cause an explosion, ignite a fire or harm
bystanders and result in serious injury.
WARNING! Parking the vehicle too close to any combustible materials
or vapours may cause an explosion, ignite a fire or harm someone
standing close by. Before initiating the forced stationary regeneration,
walk around the vehicle and make sure that there is at least 2 m (6.5
DW63246305.book Page 214 Friday, March 22, 2019 4:54 PM
To Next Page
Loading...
