276
Driver assist systems
TPM warnings in master display
The TPM functions include monitoring
of:
– Tyre pressure
NOTE: The reference
values for the tyre
pressure can be
changed:
–By the driver
(optional).
– By a DAF Service
dealer.
– Tyre temperature
– Sensor battery status
In case of an active TPM warning:
1. Select 'Vehicle info' in the main menu of the master display, using the 'Menu
Control Switch'.
2. Select 'Tyre information'.
3. Check all tyre information, by scrolling through the different screens of truck and
when fitted, trailer or trailers and spare wheel.
When the value is incorrect, it is highlighted with a coloured outline.
NOTE: Scrolling through the different screens or changing from
pressure to temperature is done turning or pushing the Menu Control
Switch (MCS). The selected choice lights up orange.
4. Let the tyres cool down and/or adjust the tyre pressure or have the defective sensor
replaced at the next service at the DAF Service dealer.
NOTE: If not resolved, TPM warnings are repeated every key-cycle.
TPM programming
After switching on the ignition, it takes up to 2 minutes before all TPM measured values
are displayed on the master display.
If no values appear after 2 minutes plus, the missing information remains shown as "-
.-".
A DAF Service dealer must program TPM;
– when, no value is displayed even after the vehicle has moved and/or,
– if a wheel position on the vehicle has changed,
TPM scree n examples
D005225-2
Pressure
8.2
8.2
8.4
8.2
Ref: 8.2 8.2
Tyre pressure low
6.6
8.2
bar
DW63246305.book Page 276 Friday, March 22, 2019 4:54 PM
To Next Page
Loading...
