331
Emergency repairs
5. Fit a jack under the jacking point at the wheel to be replaced.
6. Jack up the vehicle and place a support under the axle.
7. Remove the wheel nuts and take the wheel off the hub.
Installing wheels
1. Clean the fitting edge of the wheel
hub by scraping off dirt and
corrosion with a scraper.
2. Apply a thin layer of grease to the
fitting edge of the wheel hub.
3. Also apply a thin layer of grease to
the fitting edge of the rim. This
grease layer must prevent the rim
and the wheel hub from becoming
'rust-bound'.
4. Check whether the contact surfaces
of the rim and the drum brake are
clean. Clean them if necessary.
5. Clean the wheel nuts and then apply
a drop of oil between the thrust
washer and the nut.
6. Also apply a drop of oil to the first
turn of the wheel stud screw
threads.
D001643
D001644
DW63246305.book Page 331 Friday, March 22, 2019 4:54 PM
To Next Page
Loading...
