- 155 -
You can adjust the tracking sensitivity of Auto Focus. (l 46)
≥ This function’s default setting is “5”.
You can adjust the effective area width for Auto Focus according to the size of the subject. (l 47)
This enables/disables the Wave Form Monitor function. (l 87)
This sets the type of Wave Form Monitor. (l 87)
This sets the display positions of Wave Form Monitor. (l 87)
* Not displayed when [ZEBRA 2]/[MARKER] is set to [
OFF]. (l 171)
Switch between the zebra display and marker display.
≥ For information on the zebra display and marker display, refer to page 88.
This sets the display duration of the zebra display.
[AF SENSITIVITY]
[AF AREA WIDTH]
[WFM]
[ON]/[OFF]
[WFM TYPE]
[WAVE]/[VECTOR]/[WAVE/VECTOR]
[WFM POSITION]
[TOP/LEFT]/[TOP/RIGHT]/[BOTTOM/LEFT]/[BOTTOM/RIGHT]
[ZEBRA]
[ZEBRA 1]/[ZEBRA 2]*/[MARKER]*/[OFF]
[ZEBRA MODE]
[CONTINUE]: Displays the zebra display until it is switched to another zebra display setting.
[MOMENT]: Displays the zebra display for approximately 5 seconds.
To Next Page
Loading...
