- 87 -
≥ Register “WFM” to a USER button. (l 74)
This function displays waveforms on the LCD monitor.
Press USER button in the recording screen.
≥ When [WFM TYPE] is set to [WAVE] or [VECTOR], each press of the button enables/disables
WFM.
≥ When [WFM TYPE] is set to [WAVE/VECTOR], each press of the button switches the setting.
WAVE (wave display) # VECTOR (vector display) # OFF
≥ If you have enabled WFM by touching the applicable USER button icon, set [WFM] to [OFF] to
disable it.
≥ This function is not available in the following cases:
j When using the viewfinder
j When recording yourself (l 28)
j When using Focus Assist (l 48)
j During Freeze Frame (l 81)
j When color bars are displayed. (l 95)
≥ [WFM] will be canceled in the following cases:
j If you turn the unit off
j If you press the THUMBNAIL button
j When [USB MODE SELECT] is set to [DEVICE] and this unit is connected to a PC. (l 122)
∫ To change the type of WFM
Select the menu.
≥ This function is not available in the following cases:
j When using Focus Assist (l 48)
j During Freeze Frame (l 81)
j When color bars are displayed (l 95)
∫ To change the display position of WFM
Select the menu.
≥
You can also change the waveform position to the upper left, upper right, bottom left or bottom
right by performing one of the following operations while a waveform is displayed:
j Rotating the jog dial
j Sliding the waveform while touching it.
WFM
: [SW SETUP] # [WFM TYPE] # desired setting
[WAVE]: Displays waveforms as waves.
[VECTOR]: Displays waveforms as vectors.
[WAVE/VECTOR]: Switches the setting each time the applicable USER button is pressed.
: [SW SETUP] # [WFM POSITION] # desired setting
[TOP/LEFT]/[TOP/RIGHT]/[BOTTOM/LEFT]/[BOTTOM/RIGHT]
To Next Page