Panasonic AW-HE130W - Page 117


Video
Symptom Cause and solution Reference pages
No pictures are displayed or the
pictures are disturbed
• Has the unit been connected properly to the other connected devices? P.@@toP.@@
• If the system is configured in such a way that the picture is also switched when
the unit to be operated is selected, has the correct unit been selected?
P.<?>
• Has the image signal setting been selected correctly? P.@@,P.@@
• Are external sync signals that are supported by the video signal format which
has been set being input?
P.<?>
The picture is flipped vertically • Has the stand-alone (Desktop) installation setting been selected correctly? P.@@,P.@@
Multiple color bands (color bars) are
displayed
• Switch to the camera picture. P.<?>
The menu screen is displayed • Exit the camera menu. P.@@toP.@@
It is difficult to view the menu
screens
• Depending on the HDMI monitor you are using, you may experience one or more
of the symptoms described below. These symptoms are especially noticeable
when any of the SD formats is used: This is normal and not indicative of any
trouble.
• Theresolutionofthecharactersinthecameramenudisplayschangesasthe
backgroundimagechanges.
• Dependingontheedgeenhancementsettingestablishedforthemonitor,whitelines
appearinfrontoftheblackshadowsofthecameramenus.
• Dependingontheedgeenhancementsettingestablishedforthemonitor,the
backgroundcolorsmaybesuperimposedontothewhitepartsofthecameramenus.
–––
No auto focusing
• Is the focus set to manual?
 → Autofocusingisinitiatedassoonasthefocusissettoauto.
P.<?>
• In some situations, it may be hard to focus at the auto setting.
 → Incaseslikethis,selectthemanualsetting,andfocusmanually.
P.<?>
The subject is not brought into focus
during zooming when the manual
setting is used for the focus
• Was the focus adjusted at the Tele end?
 → FirstadjustthefocusattheTeleendwherethefocusingaccuracyishigher,and
thenproceedwiththezooming.
–––
• Under some operating conditions, it may be hard to bring subjects into focus.
 → Insuchcases,usethefocusattheautosetting.
P.<?>
Focusing is not possible in night
mode
• Are you shooting with visible light?
 →Thefocuspositionisdifferentduetothedifferenceinrefractiveindexbetween
visiblelightandinfraredlight.Wavelengthsnear900mmareassumedforinfrared
lightinnightmodeonthisunit.
Performmanualadjustmentifnecessary.
P.@@
1080/59.94p images are not output
• Is the format set to 59.94p?
 →Configuretheformatsetting.
P.@@
1080/29.97p(25p) images are not
output
• Is the monitoring mode set to VIDEO OUT mode?
 →SetthemonitoringmodetoIPmode.
P.@@
1080/29.97PsF images appear jerky
• This is normal operation.
 →InthePsF(ProgressivesegmentedFrame)format,anidenticalimageiscaptured
tofields1and2inordertooutputthesameimageasprogressive.Therefore,the
imagewillappearslightlyjerky.
–––
Something is wrong with the
coloring of the pictures
• Activate the ATW (Auto tracking white adjustment) function. P.<?>
• In some situations, the proper colors may not be reproduced using the ATW
function.
 → Incaseslikethis,proceedwiththewhitebalanceadjustment.
P.@@toP.@@
116
117
Troubleshooting (continued)