Panasonic AW-HE130W - Preset Memories

Thisunitenablesupto100settingsforthecameradirection(panning
andtilting),zoom,focus,iris,gainandwhitebalancetoberegisteredin
itspresetmemories,andcalled.
However,thenumberofsettingsthatcanberegisteredandcalled
dependsonthetypeofwirelessremotecontrolorcontrollerthatisused
foroperation.
• Thefocusandirisoperatingmodes(manualandautosettings)are
neitherregisterednorrecalled.Thecurrentfocusandirisvaluesare
registered.
• Thefocusandirisvaluescanberecalledonlywhenthemanual
settingsareapplicable.
• Forthewhitebalance,thecurrentWhiteBalanceModeadjustment
valuesareregistered.IfapresetvalueisrecalledwhenAWBA
orAWBBisselected,theadjustmentvalueselectedwhenitwas
registeredasapresetwillberecalled.TheRGainandBGainvalues
returnto0insuchcases.
<NOTE>
• Whenthereisalargedifferenceintheenvironmentaltemperature
betweenthetimeofregistrationandthetimethesettingiscalled,
displacementofthepresetpositionmayoccur.
• Ifdisplacementoccurs,performregistrationagain.
• Whenamanualoperationisperformedforpan,tilt,zoom,focusoriris
duringpresetrecall,thepresetoperationforthepan,tilt,zoom,focus
oririsoperationconcernedwillbeaborted.
• Ifanotherpresethasbeenrecalledduringanongoingpresetrecall,
thepresetbeingrecalledisaborted,andoperationforthepresetcalled
lastisperformedinstead.
When performing operations from a wireless
remote control
Twelvesettings(presetNo.1toNo.12)canberegisteredandcalled
usingthewirelessremotecontrol.
The<1>to<12>buttonscorrespondtotheunit’spresetmemoriesNo.1
toNo.12.

Registering the settings in the preset memories
1. Display the picture to be shot on the monitor.
Operatethepan,tiltorzoombuttonstodeterminethecameraangle.
Adjustthefocus,iris,gainandwhitebalanceiftheyneedtobe
adjusted.
2. While holding down the <PRESET> button, press the
button corresponding to the preset memory number.
• Ifapresetmemorynumberwithanalreadyregisteredsettinghas
beenselected,theexistingsettingwillbeerasedandreplacedwith
thenewone.

Calling the settings of the preset memories
1. Press the button in which the preset memory setting has
been registered.
When performing operations from a controller
When using a AW-RP50, AW-RP120, or AK-HRP200
Upto100entriescanberegistered/recalled.
Fordetails,refertotheoperatinginstructionsforthecontroller.
Preset memories
30
31