Panasonic AW-HE130W - Wireless Remote Control (Optional Accessory)

This unit can be operated by remote control using a wireless
remote control (model number: AW-RM50G) purchased separately.
Check out the following points before using the wireless remote
control.
z Point the wireless remote control at the unit’s wireless
remote control signal light-sensing area (front panel or
back panel), and operate it within a range of 10 meters
(32.8 ft) from these areas.
z Refer to “Layout of wireless remote control signal
light-sensing areas” on the right.
z The signal sensing distance is reduced if the angle at
which the wireless remote control signals are sensed is
increased.
Thelight-sensingsensitivityisreducedtoaboutone-halfwhenthe
wirelessremotecontrolispointedatanangleof40degreesfrom
eachpositioninfrontofawirelessremotecontrolsignallight-sensing
area(frontpanelorbackpanel).
Iftheremotecontrolisoperatedfromthebehindtheunit,itmaybe
eitherdifficultorimpossibletoperformthedesiredoperations.
z If the unit is installed near fluorescent lights, plasma
monitors or other such products or if the unit is
exposed to sunlight, the effects of the light may make it
impossible for the unit to be operated using the wireless
remote control.
Besuretofollowthestepsbelowforinstallationanduse.
• Takestepstoensurethatthewirelessremotecontrolsignallight-
sensingareawillnotbeexposedtothelightfromfluorescentlights,
plasmamonitorsorothersuchproductsorfromthesun.
• Installtheunitawayfromfluorescentlights,plasmamonitorsand
othersuchproducts.
z For about 10 minutes even after the batteries have been
removed from the wireless remote control, the selection
of the operation to be performed (the <CAM1>, <CAM2>,
<CAM3> or <CAM4> button which was pressed last) will
remain stored in the memory.
When a longer period of time elapses, however, the
selection is reset to the status established when the
<CAM1> button was pressed.
Layout of wireless remote control signal light-sensing areas
<NOTE>
• Thearrowsinthefigurebelowshowthelight-sensingdirectionsin
whichthewirelessremotecontrolsignalstravel.
Approx.
45°
Approx.
45°
Wireless remote control
signal light-sensing area
(back panel, 1 place)
Wireless remote
control signal light-
sensing area (front
panel, 2 places)
Approx.
45°
Approx.
45°
• Top view
• Rear panel view
Wireless remote control (optional accessory)
16
17