4. Check [Enable Image Buffer/Transfer] to enable the trigger.
5. Select [Timer] from the pull-down menu, then click [Next].
6. Under [Time], select the days of the week when the trigger will be active.
7. Select the time of day the trigger will be active, or click [Always] to enable the trigger for the full 24 hours
of each day selected.
8. Under [Image Setting], select the desired image format, image resolution, and image quality.
• The image quality setting is not available when [MPEG-4] is selected as the image format.
• When configuring the trigger to transfer images to a mobile phone’s E-mail address, set the image
resolution to 192 ´ 144, and set the image quality to [Favor Motion].
9. Under [Image Buffer Frequency], select the desired buffer or transfer rate.
10. Under [Transfer Method], select the desired transfer method.
28 Operating Instructions
2.1 Configuring a Timer Trigger
To Next Page
Loading...
