• MPEG-4 images cannot be transferred.
– [No Transfer, No Memory Overwrite]: Images are not transferred. Images are buffered until the
camera’s memory is full.
– [No Transfer, Memory Overwrite]: Images are not transferred. Once the camera’s memory is full, new
images replace the old images.
– [FTP]: After an image is captured, it is transferred to the specified FTP site.
– [E-Mail]: After an image is captured, it is sent to the specified E-mail address.
– [HTTP]: After an image is captured, it is transferred to the specified website.
11. Follow the procedure below based on the settings you made under [Transfer Method].
a. If you selected to not transfer images (i.e., to buffer images only), click [Save] to finish.
• All buffered images for the selected trigger are deleted when you click [Save].
b. If you selected to transfer images by FTP, E-mail, or HTTP, click [Next].
• The appropriate transfer settings page is displayed.
– For FTP transfer, see Page 37.
– For E-mail transfer, see Page 39.
– For HTTP transfer, see Page 42.
Note
• In order for this feature to work as expected, make sure the camera’s date and time setting is correct
(see Page 95).
• When selecting the buffer or transfer rate, keep in mind that the actual rate may be slower depending
on network conditions, the number of people accessing the camera, and the type of objects being
viewed.
Operating Instructions 29
2.1 Configuring a Timer Trigger
To Next Page
Loading...
