Panasonic CS-VZ9SKE - Page 147

147
18.1.12 Removing the Drive Motor of the Vertical and Horizontal Direction Louver (Left
side)
1 Perform “18.1.1 Removing the Front Panel”.
2 Perform “18.1.2 Removing the Air Filters”.
3 Perform “18.1.3 Removing the Front Grille (Right) and Front Grille (Left)”.
4 Perform “18.1.4 Removing the Control Board (Electronic Controller)”.
5 Perform “18.1.8 Removing the Indicator, Receiver & Human Sensor Control Board to below side”.
6 Perform “18.1.9 Removing the Indicator, Receiver & Human Sensor Control Board from unit”.
7 Perform “18.1.10 Removing the Electronic Controller Box and Bracket”.
8 Release the lever from the horizontal louver.
9 Remove the screws (4 pieces) from the drive motor complete and remove it from unit.
Screw
Horizontal louver connecting lever
18.1.13 Removing the Front Grille Bracket (Frame - Air Filter)
1 Perform “18.1.1 Removing the Front Panel”.
2 Perform “18.1.2 Removing the Air Filters”.
3 Perform “18.1.3 Removing the Front Grille (Right) and Front Grille (Left)”.
4 Perform “18.1.4 Removing the Control Board (Electronic Controller)”.
5 Perform “18.1.8 Removing the Indicator, Receiver & Human Sensor Control Board to below side”.
6 Perform “18.1.9 Removing the Indicator, Receiver & Human Sensor Control Board from unit”.
7 Perform “18.1.10 Removing the Electronic Controller Box and Bracket”.
8 Perform “18.1.11 Removing the nanoe Controller Box”.
9 Remove the screws (4 pieces) of the front grille panel and remove it from unit.
Screw
Screw