Panasonic DC-BGH1

- 232 -- 232 -
12. Remote Operations - Wi-Fi Connections
■
[WPS (Push-Button)]
Press the WPS button on the wireless access point to set up a connection.
Press the wireless access point WPS button until it switches to WPS mode.
Example)
■
[WPS (PIN code)]
Enter a PIN code into the wireless access point to set up a connection.
Select the wireless access point you are connecting to.
Enter the PIN code displayed on the screen of the output destination into the wireless access point.
Press [MENU/SET] on the camera.
■
[From List]
Searches for a wireless access point to use, and connects to it.
●
Confirm the encryption key of the wireless access point.
Select the wireless access point you are connecting to.
●
Press [Fn1] to run a wireless access point search again.
●
If no wireless access point is found, refer to “Connecting by Manual Input” below.
(If network authentication is encrypted)
Enter the encryption key.