Getting started
VQT3C84
13
Required setting:
Set “HDMI Audio Output” to “On” (> 81).
(The default setting is “On”.)
≥ The HDMI connection supports VIERA Link “HDAVI Control” (> 68).
About HDMI cable
≥Please use High Speed HDMI Cables that have the HDMI
logo (as shown on the cover).
≥When outputting 1080p signal, please use HDMI Cables
5.0 meters or less.
≥Recommended Panasonic HDMI cable part number:
RP-CDHS15 (1.5 m), RP-CDHS30 (3.0 m), RP-CDHS50
(5.0 m), etc.
≥ You cannot connect this unit to DVI devices that are incompatible with
HDCP.
Depending on the device, images may not display properly or at all when
connecting with a DVI/HDMI switching cable. (Audio cannot be output.)
≥ If you are connecting to a TV that is only compatible with 2 channel
audio output, audio with 3 channels or more will be down mixed (> 107)
and output as 2 channels, even if connecting with an HDMI cable.
(Some discs cannot be down mixed.)
When the unit is not to be used for a long time
To save power, unplug it from the household mains socket.
This unit consumes a small amount of power, even when it
is turned off
[approx. 0.2 W (“Power Save in Standby” is activated
and “RF OUT ( Aerial Signal )” is set to “Off”)]
DMRPWT500GL_eng.book 13 ページ ２０１１年２月１７日 木曜日 午後１時１７分
To Next Page
Loading...
Need help?
General
