Getting started
VQT3C84
23
∫ Network Easy Setting ( Internet
Connection Test )
≥If there is no problem, the following screen is displayed.
≥If there is any problem, the following message is
displayed on the screen.
To restart Network Easy Setting
1 Press [FUNCTION MENU].
2 Select “Setup” in “Others”, then press [OK].
3 Select “Network Easy Setting” in “Network”, then press
[OK].
To redo settings individually
1 Press [FUNCTION MENU].
2 Select “Setup” in “Others”, then press [OK].
3 Select “Network Settings” in “Network”, then press [OK].
4 Select “IP Address / DNS Settings” (> 82) or “Proxy
Server Settings” (> 82), then press [OK].
Check security before using Home Network ( DLNA )
Server function
If you set “Home Network ( DLNA ) Server function” to “On”,
all connected devices on the same network can access this
unit. Ensure that the router for your home network has
adequate security system to prevent unauthorized access.
≥ Refer to the operating instructions of the hub or router.
≥ Home Network ( DLNA ) Server function setting can be set only when
you selected “Off” for “Power Save in Standby” in “Easy Setting”. (> 20,
step 3)
≥ Even if you set “Home Network ( DLNA ) Server function” to “Off”, it is
possible to set to “On” later. (> 83)
≥ You can perform this setup anytime by selecting “Network Easy Setting”
in the Setup menu. (> 82)
≥ You can redo these settings individually using “Network Settings”.
(> 82)
≥ Do not use this unit to connect to any wireless network for which you do
not have usage rights.
During automatic searches in a wireless network environment, wireless
networks (SSID) for which you do not have usage rights may be
displayed; however, using these networks may be regarded as illegal
access.
≥ After performing network settings on this unit, the settings (encryption
level, etc.) of the Wireless router might change. When you have trouble
getting online on your PC, perform the network settings on your PC in
accordance with the settings of Wireless router.
≥ Please be aware that connecting to a network without encryption may
result in the content of the communication being illegitimately viewed by
a third party, or the leaking of data such as personal or secret
information.
Display Check the following
Cannot find the
server. (B019)
≥“Primary DNS” and “Secondary
DNS” settings of “IP Address /
DNS Settings” (> 82)
Failed to connect to
the server. (B020)
≥The server may be busy or the
service may have been
suspended. Please wait a few
moments, and then try again.
≥Settings of “Proxy Server
Settings” (> 82) and the router
OK
Network Easy Setting (Internet Connection Test)
Completed.
Press OK.
Network connection check has finished.
Internet functions are available.
- Connection to the internet. : Pass
DMRPWT500GL_eng.book 23 ページ ２０１１年２月１７日 木曜日 午後１時１７分
To Next Page
Loading...
Need help?
General
