Convenient functions
VQT3C84
83
¾ Home Network ( DLNA ) Server Settings
You can set the DLNA (Server) function (> 70)
¾ Home Network ( DLNA ) Server
function
You can switch between enable/disable of the DLNA
(Server) function.
≥If “On” is selected, “Power Save in Standby” is
fixed to “Off”. (> right)
¾ Setting device name
It is also possible to change the name of this unit on
the network.
≥Select from a preset list
Select the preset name, then press [OK].
≥Create name
Enter the name. (> 66, Entering text)
¾ Registration type for remote devices
¾ Remote device list
≥This function cannot be enabled when “Manual” is
selected in “Registration type for remote devices”.
(> above)
≥To register equipment manually
1 Select the device name or the MAC Address for
the device you want to register, then press
[OK].
2 Select “Yes”, then press [OK].
≥To deregister equipment
1 Select the registered equipment, then press
[OK].
2 Select “Yes”, then press [OK].
∫ Standby Settings
¾ Power Save in Standby
≥This function cannot be enabled when the DLNA
function is enabled in “Home Network ( DLNA )
Server Settings”. (> left)
≥The setting may be changed to “Off” automatically
when the setting for video communication is changed.
(> 67)
¾ Automatic Standby
Set the time to turn the unit to standby mode
automatically.
After the unit has finished operating, the unit will be
turned to standby mode once the set time has passed.
≥When “REWIND LIVE TV” is set to “On”(> 77), “Off”
cannot be selected.
Automatic All connected devices on the same
network can access this unit.
Manual Only registered devices can
access this unit.
≥ The maximum number of equipment that can be registered is
16.
Network Settings
Home Network ( DLNA ) Server Settings
Home Network ( DLNA ) Server Settings
Home Network ( DLNA ) Server function
Setting device name
Registration type for remote devices
Remote device list
Others
On It will go into the “Power Save in
Standby” mode.
On Timer “Power Save in Standby” is activated
when the set time comes.
≥If the clock has not been set, “Power
Save in Standby” is activated at all
hours.
Off It is possible to start quickly from the
standby mode. (Quick Start mode)
Setup
Others
Others
Standby Settings Enlgish
Remote Control
Clock
PIN Entry
System Update
System Information
DivX Registration
Initialize
Others
Standby Settings Enlgish
Standby Settings
Power Save in Standby Enlgish
Automatic Standby
Automatic Standby after OTR
Automatic Standby after Copy
RF OUT ( Aerial Signal )
DMRPWT500GL_eng.book 83 ページ ２０１１年２月１７日 木曜日 午後１時１７分
To Next Page
Loading...
Need help?
General
