Panasonic DP-1820P

334
SEP 2004
Ver. 1.2
DP-1520P/1820P/1820E
(11) Remove the Panel Sub Cover.
(12) Install the Key Assembly into the Control Panel
Assembly.
(13) Remove 10 Screws.
(14) Remove the Rear Cover.
(15) Install the Hardware Key into one of the three
available connectors (CN67, CN68 or CN69) on
the SC PC Board.
Note:
The connectors are keyed, to prevent damage to
the SC PC Board, install the Hardware Key as
illustrated. Do not force the Hardware Key into the
connector if facing the wrong way.
(16) Proceed with the installation of other options.
If finished, reinstall all Harnesses and Covers.
(17) Plug the AC Power Cord and turn the Power
Switch on the Right Side of the machine to the
ON position.
(18) Reconnect the Telephone Line Cable if it was
disconnected.
(19) Install the Panasonic-DMS Software into the PC
with the Operating Instructions by following the
prompts of the Installation Wizard.