Panasonic DP-1820P

329
SEP 2004
Ver. 1.2
DP-1520P/1820P/1820E
8.2. Installing the Printer Controller Module for PCL6 (DA-PC180)
8.2.1. Contents
Note:
1. The part number(s) may differ depending on the Destination.
2. Refer to the Parts List in the Parts Manual.
8.2.2. Installation
1. Before installing this option, make sure the Program Expansion Board (DA-EM600) is installed
into Slot 1 on the SC PC Board first. Refer to the Installation Instructions of the Program
Expansion Board (DA-EM600).
2. Install the Hardware Key by following the steps below.
CAUTION!
Turn the Power Switch on the Right Side of the machine to the OFF position, and then
unplug the AC Power Cord before beginning installation. (During a Lightning Storm, to
prevent electrocution disconnect the Telephone Line Cable first before unplugging the
AC Power Cord, if the Fax Option is installed.)
Qty. Description Part No. Remarks
1 Hardware Key ----- PCL KEY
1 Software CD See Note Includes Operating Instructions
1 License Agreement -----
1 Installation Instructions DZSM000816 This document
(1) Remove 10 Screws.
(2) Remove the Rear Cover.
(3) Install the Hardware Key into one of the three
available connectors (CN67, CN68 or CN69) on
the SC PC Board.
Note:
The connector is keyed, to prevent damage to
the SC PC Board, install the Hardware Key as
illustrated. Do not force the Hardware Key into
the connector if facing the wrong way.