Panasonic DP-1820P

361
SEP 2004
Ver. 1.2
DP-1520P/1820P/1820E
8.9. Installing the Expansion F-ROM Board (DA-EM600)
8.9.1. Contents
Note:
1. The part number(s) may differ depending on the Destination.
2. Refer to the Parts List in the Parts Manual.
8.9.2. Installation
CAUTION!
Turn the Power Switch on the Right Side of the machine to the OFF position, and then
unplug the AC Power Cord before beginning installation. (During a Lightning Storm, to
prevent electrocution disconnect the Telephone Line Cable first before unplugging the
AC Power Cord, if the Fax Option is installed.)
Qty. Description Part No. Remarks
1 Expansion F-ROM Board DZEC102137
2 PC Board Support DZJH000084
1 Installation Instructions DZSM000756 This document
(1) Remove 10 Screws.
(2) Remove the Rear Cover.
(3) Remove the Black Pin Protector from Slot 1
(CN62), if it was preinstalled.
(4) Install 2 PC Board Supporters for the Slot 1 on
the SC PC Board.
(5) Install the Program Expansion Board into Slot
1 (CN62) on the SC PC Board and secure with
the Supporters.
Note:
The Program Extension F-ROM Board must
always be installed into Slot 1 (CN62) for the PCL
or PCL/PS Printer Option to function.
(6) Proceed with the installation of other options.
If finished, reinstall all Harnesses and Covers.
(7) Plug the AC Power Cord and turn the Power
Switch on the Right Side of the machine to the
ON position.
(8) Reconnect the Telephone Line Cable if it was
disconnected.