364
SEP 2004
Ver. 1.2
DP-1520P/1820P/1820E
8.12. Installing the Accounting Software (DA-WA10)
8.12.1. Contents
Note:
1. The part number(s) may differ depending on the Destination.
2. Refer to the Parts List in the Parts Manual.
8.12.2. Installation
1. Before installing this option, make sure the Hard Disk Drive Unit (DA-HD18) is installed into
the machine first. Refer to the Installation Instructions for the Hard Disk Drive Unit (DA-HD18).
2. Install the Accounting Software into the PC with the Operating Instructions by following the
prompts of the Installation Wizard.
3. Set the Key/Dept. Counter function by following the steps below.
1) Press “FUNCTION”, “ORIGINAL SIZE”, and “3” keys sequentially to enter the Service
Mode.
2) Press the "5" key to enter the F5 Mode (Function Parameters).
3) Press the "START" key.
4) Press the "4", "2" and "SET" keys sequentially to enter the F5-42 "KEY/DEPT. COUNTER".
5) Press the "2" and "SET" keys to activate the Key/Dept. Counter function.
6) Press the "STOP" key.
Note:
The factory default setting for the Key Operator ID Code is "000", to ensure security it is
recommended to change this code.
To change it:
• While in the Service Mode, press "7" to enter the F7 Mode (Electronic Counter).
• Press the "START" key to select "01 KEY OPERATOR ID CODE".
• Press the "SET" key, and input a 3-digit code.
• Press the "SET" key, and press "STOP" key to exit F7 Mode (Electronic Counter).
7) Press “FUNCTION” and “CLEAR” keys simultaneously to exit the Service Mode.
4. Set the Key/Dept. Code by following the steps below.
1) Press the "FUNCTION" key, press "V" or "/\" arrow keys to select "GENERAL SETTINGS"
and press "SET" key.
2) Press "V" or "/\" arrow keys to select "09 KEY OPERATOR MODE" and input the 3 Digit
Code and press "SET" key to enter the Key Operator Mode.
3) Press "V" or "/\" arrow keys to select "13 DEPT. COUNTER MODE".
4) Press "2" and "SET" keys.
5) Press "V" or "/\" arrow keys to set the Dept. Counter Codes (up to 300).
6) Press the "STOP" key to return to the standby mode.
Qty. Description Part No. Remarks
1 Accounting Software CD ----- Includes Operating Instructions
1 License Agreement -----
1 Installation Instructions DZSM000741 This document
To Next Page
Loading...
