Panasonic DP-1820P

371
SEP 2004
Ver. 1.2
DP-1520P/1820P/1820E
8.13.3. Double Exposure Lead and Side Edge Adjustments
Caution:
Confirm that the Scanning Pad is installed and aligned correctly on the ADF/i-ADF prior to making
any adjustments.
1. Place a Business Card, Driver's License, Insurance Card, etc. (Invoice size or smaller) on the
Platen Glass as illustrated.
2. Insert Letter or A4 size paper into the 1st Paper Tray or onto the Sheet Bypass and change the tray
settings to the appropriate paper size.
3. Make a copy using the Double Exposure Copy Mode.
4. Check the Copy Image.
a. For a Horizontal Black Line in the Center, adjust the Service Mode F6-63 (Lead Edge Read
Timing) by following the steps below.
b. For a Vertical Black Line at the Leading Edge, adjust the Service Mode F6-64 (Side Edge Read
Adjust) by following the steps below.
5. Press “FUNCTION”, “ORIGINAL SIZE” keys and then Key “3” on the keypad sequentially.
6. Perform the Service Mode F6-63 (Lead Edge Read Timing) and F6-64 (Side Edge Read Adjust).
Note:
It is not recommended setting the value higher than "4" as it will increase the Void Area.
7. Press "STOP" first and then press "FUNCTION" + "CLEAR" keys simultaneously to return to
standby.
8. Repeat the above steps 3 to 7 until the Black Line(s) disappear.
Platen
Driver's License
Adjust with F6-63
O
utput of Letter (A4) Paper (not LTR-R)
Driver's
License
Driver's
License
Adjust with F6-64
Driver's
License
Driver's
License