402
SEP 2004
Ver. 1.2
DP-1520P/1820P/1820E
(24) Disconnect the Harness on the CST2 PC Board
(CN772).
(25) Release the Harness from the Edge Saddle.
(26) Route the Harness through a hole on the frame.
(27) Slide the 2nd Paper Tray out of the unit.
(28) Remove 5 Screws.
(29) Separate the 3rd Paper Tray from the 2nd
Paper Tray.
(30) Install the Heater, refer to Steps (11) - (21).
For a 3-Paper Tray Configuration, skip to Step
(47).
(31) Remove 4 Silver Screws.
(32) Remove the Rear Paper Tray Cover.
(33) Disconnect the Harness on the CST3 PC Board
(CN808).
(34) Release the Harness from the Edge Saddle.
(35) Route the Harness through a hole on the frame.
To Next Page
Loading...
