Panasonic DP-1820P

418
SEP 2004
Ver. 1.2
DP-1520P/1820P/1820E
(13) Remove the OPC Drum Shaft Holder
Assembly.
(14) Remove the Roller Spacer.
(15) Lift the OPC Drum, holding the left side where
the OPC Drum Shaft Holder Assembly was
installed.
(16) Ensure that the OPC Drum is fully coated with
the Drum Starting Powder. Apply additional
Drum Starting Powder onto the surface of the
OPC Drum if required.
Note:
Do not touch the surface of the OPC Drum with
bare hands when removing or reinstalling it.
Grease from fingerprints will affect copy quality.
Caution:
The OPC Drum is sensitive to light. To prevent
optical exposure problems, do not expose the
OPC Drum to direct sunlight or bright light.
Even if it is a fluorescent lamp, approx.1000 lm/m
2
(1000 lx).
(17) Install the new OPC Drum onto the OPC Drum
Shaft Holder.
(18) Insert the OPC Drum Assembly into the Process
Unit.
(19) Reinstall the Process Unit, Toner Bottle and the
Toner Waste Container.
(20) Close the all Covers.
(21) Perform the Copy Service Mode F8-14 (OPC
Counter Starting Point Adjustment) to clear the
OPC Drum Counter.