Panasonic DP-1820P

43
SEP 2004
Ver. 1.2
DP-1520P/1820P/1820E
(26) Remove the Snap Ring (S9).
(27) Remove the Torque Limiter Bushing (2510)
and Torque Limiter Spring (2511).
Note:
When reinstalling the Torque Limiter Assembly,
ensure that the Torque Limiter Spring is placed
into the deeper slot of the Separation Roller.
<Cleaning Torque Limiter Bushing and Torque
Limiter Spring>
Clean the Torque Limiter Bushing and Torque
Limiter Spring with a soft cloth, saturated with
isopropyl alcohol.
(28) Remove the Separation Roller (2509).
<Cleaning Separation Roller>
Clean the Separation Roller with a soft cloth,
saturated with isopropyl alcohol.
(29) Disconnect the Read Point Sensor Harness
(2858) and remove Sensor (131) (Original
Detection Sensor).
(30) Disconnect all Harnesses on the ADF PC
Board.
(31) Remove 2 Screws (19).
(32) Remove the i-ADF PC Board (2847).
(33) Remove 2 Screws (24).
(34) Remove the ADF Motor (2601).