Panasonic DP-8032 - Page 139

139
DP-8032/8025
2008Ver. 1.2
settings of the unit:
Default Gateway IP Address:
DNS Server IP Address:
Subnet Mask: (whether it is valid)
For Windows 98 / Me / 2000 / NT / XP
The following example shows the output after you type "ipconfig /all" at a command prompt:
From the above examples, you know the Network configuration for the specified Subnet Mask is as
follows: IP Address: 192.168.3.4; Subnet Mask: 255.255.255.0; Default Gateway (Default Router IP
Address): 192.168.3.254; DNS Server: 192.168.1.1 and the Domain Name: labo.pcc.com
(obtained from the Host Name).
3. Using “PING” to Test Physical Connectivity
The Packet Internet Groper (PING) is a command-line tool included with every Microsoft TCP/IP client
(any DOS or Windows client with the TCP/IP protocol installed). PING is a simple utility that is used to
send a test packet to a specified IP Address or Hostname, then, if everything is working properly, the
packet is echoed back (returned).
Sample command-line PINGing and parameters are shown below. There are several available options
that can be specified with the PING command. However, for our examples, we will use two options (-n
and -w) which are commonly used when the response from the destination location is too long.
PINGing the Unit
-n count : The number of echo requests that the command should send. The default is four.
-w timeout : Specifies the period PING will wait for the reply before deciding that the host is not
responding.
C:\>ipconfig /all
Windows NT IP Configuration
Host Name : ec4.labo.pcc.com
DNS Servers : 192.168.1.1
Node Type : Hybrid
NetBIOS Scope ID :
IP Routing Enabled. : No
WINS Proxy Enabled : No
NetBIOS Resolution Uses DNS : No
Ethernet adapter IBMFE1 :
Description : IBM 100/10 EtherJet PCI Adapter
Physical Address : 00-04-AC-EE-9C-E8
DHCP Enabled : No
IP Address : 192.168.3.4
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.3.254
Primary WINS Server : 192.168.3.18
C:\WINDOWS>ping ef1.labo.pcc.com
Pinging ef1.labo.pcc.com [192.168.3.5] with 32 bytes of data:
Reply from 192.168.3.5: bytes=32 time=5ms TTL=253
Reply from 192.168.3.5: bytes=32 time=4ms TTL=253
Reply from 192.168.3.5: bytes=32 time=4ms TTL=253
Reply from 192.168.3.5: bytes=32 time=4ms TTL=253