Panasonic DP-8032

55
DP-8032/8025
2008Ver. 1.2
2.2.4. Process Unit
(7) While holding each side of the Bracket against the
notch, secure the Rear Lamp Belt Lock (228) and
the Front Lamp Belt Lock (227) with 2 Red Screws
(D24).
(8) Clean the Mirror 1 (264), the Mirror 2 (265), and the
Multi Beam Sensor.
Note:
1. Do not touch the surface of the Sensors with your
hands.
2. Clean any dirt or fingerprints with a Dry Cotton
Swab.
3. Do not use Isopropyl Alcohol / any Alcohol.
(1) Open the Right Cover (1201).
(2) Open the Front Cover (528).
(3) Remove the Toner Waste Container (618).
(4) Remove the Toner Bottle (617).
(5) Remove 1 Screw (19).
(6) Remove the Connector Cover (Clear Blue) (538).
Caution:
When reconnect the Harness, make sure the
connector position and its keys. Insert it gently, and do
not force the connector if it is facing the wrong way.
Caution:
When reinstalling the Connector Cover, make sure
the Harness is not nipped by the Cover.