54
DP-8032/8025
2008Ver. 1.2
<Reinstalling the Lamp Base Assembly and the Mirror 2
Bracket Assembly>
(1) Remove 2 Screws (19).
(2) Remove the Right Scanner Frame (242).
Note:
When reinstalling the Right Scanner Frame, tighten
the 2 Screws after reinstalling both sides of the F/R
Scanner Frame.
(3) Install the Mirror 2 Bracket (233) Assembly.
(4) Reinstall the 2 Inner Timing Belts (202).
Note:
The Bracket must be adjusted by moving it towards
the center until it stops against the notches in the
frame.
(5) While holding each side of the Bracket against the
notch, secure the Rear Mirror Belt Lock (238) and
the Front Mirror Belt Lock (236) with 2 Screws (18).
(6) Install the Lamp Base Bracket (224) Assembly.
Note:
The Bracket must be adjusted by moving it towards
the right edge until it stops against the notches in the
frame. Make sure that the Mirror 2 Bracket Assembly
is positioned in the notches in the center of the frame.
To Next Page
Loading...
