246
DP-8032/8025
2008Ver.1.2
7.3. Installation Procedure
Caution:
1. Refer to each individual Installation Instructions when installing Stands, or other Options.
2. The following machine illustrations/LCD/Firmware, depict a Sample Unit with the USA/Canadian
standard configuration, in details may differ depending on the Destinations etc.
3. The scanner is held in place by a Shipping Blue Screw to prevent damage during transit, and the
Pressure Roller is also locked in the opened position to avoid the possibility of damaging the Pressure
Roller.
Do Not turn the Power Switches ON before unlocking the Scanner / Pressure Roller
(see steps (6) ~ (19)).
7.3.1. Installation Procedure
(1) Pull out the Left Front Handle to lock it in place.
Note:
To release the Handle, pushing the Release Latch
toward the machine, and push the Handle into the
machine.
(2) Open the Left Rear Handle Cover, and swing the
Handle downwards to lock it in place.
To Next Page
Loading...
