Panasonic DP-8032

171
DP-8032/8025
2008Ver. 1.2
5 Service Modes
5.1. Service Modes (For Copier)
These Service Modes are provided to assist the technician in checking for abnormalities in the copier and a
means of making adjustments to the Input/Output of major components.
Caution:
The factory default parameters are preset (country dependent) for optimum performance and in
compliance with the local telecommunication regulations/standards, and do not need to be changed.
Changing some of these parameters may cause the unit to be no longer compliant or become
inoperable.
5.1.1. Service Mode Procedure
1. To select the Service Mode
Press the “FUNCTION”, “ORIGINAL SIZE (LEDGER/A3)”, and the “3” keys simultaneously.
Input the password, and select the “OK” button to enter the Service Mode (default password is
00000000).
2. To exit the Service Mode
The Service Mode is reset when the “FUNCTION” and “C (CLEAR)” keys are pressed
simultaneously.
5.1.2. Copier Service Mode Functions
Service Modes (For Copier)
Service
Mode
Item Function
F1 Self Test 00 CCD Test This test is used for checking the CCD.
01 LCD/LED Test This test is used for checking the LCD and LEDs.
02 Page Memory Test This test is used for checking the Page Memory.
03 Print Test Pattern 1 Prints the pattern for setting the Paper position alignment.
04 Print Test Pattern 2 Prints the Slant pattern for setting the Paper position
alignment.
05 Print Test Pattern 3 Prints the Grid pattern for setting the Paper position
alignment.
06 Print Test Pattern 4 Prints the pattern for setting the Duplex Paper position
alignment.
F2 Single Copy Test One sheet is copied when the Start key is pressed.
F3 Continuous Copy Test Multi copies are made when the Start key is pressed.
F4 Input / Output Status Test The functioning of Input / Output items (selected item
numbers) is checked.
F5 Function Parameters Various function settings (selected by code numbers) can
be changed.
F6 Adjust Parameters Various function settings (selected by code numbers) can
be adjusted.
F7 Electronic Counters Electronic Counters for Maintenance
F8 Service Adjustment Perform pseudo-operation of an item (selected by code
numbers)
F9 Unit Maintenance Fax Function Parameters