Panasonic DP-8032 - Page 145

145
DP-8032/8025
2008Ver. 1.2
4.6.2. Jam Error Codes (J Code)
U13 Add Toner 1. Toner Bottle incorrectly installed.
2. Low Toner.
3. Toner Sensor disconnected.
4. Toner Sensor defective.
5. SPC PCB connector disconnected.
6. SPC PCB defective.
U14 Replace Toner Waste Container 1. Toner Waste Container full.
(See Sect. 3.5.4.)
U15 No Toner Waste Container 1. Toner Waste Container not installed.
2. Toner Waste Container Sensor disconnected.
3. Toner Waste Container Sensor defective.
U16 No Developer Unit 1. Developer Unit not installed.
U18 Total Copy Limit Over 1. Department Copy Counter full.
U20 Close ADF Cover 1. ADF Cover open.
2. ADF not installed correctly.
3. ADF Cover Sensor disconnected.
4. ADF Cover Sensor defective.
5. LVPS connector disconnected.
6. LVPS defective.
U21 Close ADF 1. ADF and ADF Cover open.
2. ADF Sensor disconnected.
3. ADF Sensor defective.
U22 Close ADF Exit Cover 1. ADF Exit Cover open.
2. ADF not installed correctly.
3. ADF Exit Cover Sensor disconnected.
4. ADF Exit Cover Sensor defective.
5. LVPS connector disconnected.
6. LVPS defective.
U25 Shake Toner Bottle 1. Toner blocked in the Toner Bottle.
U90 Replace Battery 1. Internal battery requires replacement.
Section Jam Location
A Finisher
B Paper Transport Area
C Paper entry area
D2 2nd Paper Feed Unit
D3 3rd Paper Feed Unit
D4 4th Paper Feed Unit
EADF/i-ADF
User Error Codes (U Code) Table
Code Item Possible Cause(s)
A
B
C
E
D2
D3
D4