214
DP-8032/8025
2008Ver.1.2
5.2.5. Fax Service Mode 4 (Modem Test)
5.2.5.1. Binary Signal
This Service Mode is used to check the binary signal output. Signals can be output to the line using the
following procedure.
Select the “04 MODEM Tests” on the Touch Panel display.
↓
Select the “01 Binary Signal” on the Touch Panel display.
↓
Select the desired parameter on the Touch Panel display and touch the “CLOSE”.
↓
Touch the “OK” button 3 times.
↓
Press “FUNCTION” and “C (CLEAR)” keys simultaneously to exit the service mode.
Binary Signal Table
5.2.5.2. Tonal Signal
This Service Mode is used to check the tonal signal output. Signals can be output to the line using the
following procedure.
Select the “04 MODEM Tests” on the Touch Panel display.
↓
Select the “02 Tonal Signal” on the Touch Panel display.
↓
Select the desired parameter on the Touch Panel display and touch the “CLOSE”.
↓
Touch the “OK” button 3 times.
↓
Press “FUNCTION” and “C (CLEAR)” keys simultaneously to exit the service mode.
Tonal Signal Table
Number Signals
1 V21 300bps
2 V27ter 2400bps
3 V27ter 4800bps
4 V29 7200bps
5 V29 9600bps
6 V17 TC7200bps
7 V17 TC9600bps
8 V17 12000bps
9 V17 14400bps
Number Signals
1 462 Hz
2 1080 Hz
3 1100 Hz
4 1300 Hz
5 1650 Hz
6 1850 Hz
7 2100 Hz
To Next Page
Loading...
