265
DP-8032/8025
2008Ver. 1.2
(1) Remove 4 Silver Screws.
(2) Open the Rear Cover.
Caution:
If the LEDs on the SC and SPC PC Boards are lit
(ON), the Power to the machine is still ON.
Please read ā8.4.2. Installation : CAUTION!ā once
again.
(3) Release the Pre-installed 2 wire Harness from 2
Harness Clamps.
(4) Plug the FXB PC Board Assembly into the SC PC
Board with on Board Connector.
(5) Secure the FXB PC Board Assembly with 1 Screw.
(6) Connect the Pre-installed 2 wire Harness to the
FXB PC Board (CN393).
(7) Secure the Pre-installed 2 wire Harness with
Harness Clamp on the FXB PC Board.
To Next Page
Loading...
