280
DP-8032/8025
2008Ver.1.2
(3) Remove the Black Pin Protector from Slot 1 (CN62),
if it was pre-installed.
(4) Install 2 PC Board Supporters for the Slot 1 on the
SC PC Board.
(5) Install the Program Expansion Board into Slot 1
(CN62) on the SC PC Board, and secure with the
Supporters.
Note:
The Program Extension F-ROM Board must always
be installed into Slot 1 (CN62) for the PCL or PCL/PS
Printer Option to function.
(6) Proceed with the installation of other options. If finished, close and secure the Rear Cover, and
reinstall remaining Covers.
(7) Plug the AC Power Cord, and turn the Main Power Switch on the Back, and the Power Switch on the
Left Side of the machine to the ON position.
(8) Reconnect the Telephone Line / LAN Cable if disconnected.
To Next Page
Loading...
