282
DP-8032/8025
2008Ver.1.2
(3) Insert the SDRM PC Board into the Socket on the SC
PC Board as illustrated.
Caution:
Make sure to insert the SDRM PC Board at a 20 - 30°
angle into the memory socket, and then lock it down.
(4) Proceed with the installation of other options. If finished, close and secure the Rear Cover, and
reinstall remaining Covers.
(5) Plug the AC Power Cord, and turn the Main Power Switch on the Back, and the Power Switch on the
Left Side of the machine to the ON position.
(6) Reconnect the Telephone Line / LAN Cable if it was disconnected.
To Next Page
Loading...
