Panasonic DP-8032 - Page 308

308
DP-8032/8025
2008Ver.1.2
(19) Install the 2 Hinge Stoppers.
(20) Secure the 2 Hinge Stoppers with 4 Screws (Short).
(21) Install the 2 Hinge Covers.
Note:
When installing the Hinge Covers, make sure that
each Hinge Film is put inside of each Hinge Cover.
(22) Peel off the 6 Adhesive protectors from the
Scanning Pad.
(23) Place the Scanning Pad on the glass aligning on the
upper left corner, keeping 1mm space as illustrated.
(24) Close the i-ADF / ADF.
Note:
Reopen the i-ADF / ADF and push the Scanning Pad
gently to paste it properly.
(25) Lift the Original Tray Assembly.
(26) Lower the Inverting Guide 2 Assembly.
(27) Install the Stamp Assembly.
(28) The Inverting Guide 2 Assembly and the Original
Tray Assembly are returned to former position.
(29) Proceed with the installation of other options. If
finished, reinstall all Harnesses and Covers.
(30) Plug the AC Power Cord, and turn the Main Power
Switch on the Back and the Power Switch on the
Left Side of the machine to the ON position.
(31) Reconnect the Telephone Line / LAN Cable if
disconnected.
Hinge
Stopper
Hinge
Stopper
Screws
(Short)
Screws
(Short)
Hinge Cover
Hinge Film
Hinge Film
Hinge Film
1mm
Scanning
Pad
Adhesive
protectors
Adhesive
protectors