335
DP-8032/8025
2008Ver. 1.2
(9) Remove 1 Screw.
(10) Remove the Front Fixing Metal Bracket (longer
plastic tab).
(11) Remove 1 Screw.
(12) Remove the Rear Fixing Metal Bracket (shorter
plastic tab).
(13) Turn the OPC Drum Assembly in the direction of the
arrow and remove.
Caution:
Exercise caution not to scratch the surface of the
OPC Drum (Green), and not to touch it with bare
hands.
(14) Remove the OPC Drum Shaft Holder Assembly.
(15) Remove the Front DSD Arm.
(16) Lift the OPC Drum, holding the right side where the
OPC Drum Shaft Holder Assembly was installed.
(17) Clean the Bias Charge Roller with a soft dry cloth that
came with the new OPC Drum.
To Next Page
Loading...
